CH375 USB device mode is fully compatible with CH372, CH375 contains all the features of the CH372. Common CH375 USB host mode support USB full-speed device, the external microcontroller can through the CH375 in accordance with the USB protocol and USB device communication. CH375 firmware also built a dedicated protocol processing Mass-Storage mass storage devices, the external microcontroller can be directly used as the basic unit of reading and writing in sectors USB storage devices (including USB hard disk/USB flash drive/U disk).
CH375 with the 8-bit data bus and read, write, chip select control lines and interrupt output can be easily attached to the system bus of the microcontroller/DSP/MCU/MPU controller. USB host mode, CH375 also provides serial communication via serial input, serial output, and interrupt output monolithic/DSP/MCU/MPU connected.
FEATURES:
- CH375B with the 8-bit data bus and read, write, chip select control lines and interrupt output can be easily attached to the system bus of the microcontroller/DSP/MCU/MPU controller.
- USB host mode, CH375B provides serial communication via serial input, serial output, and interrupt output monolithic/DSP/MCU/MPU connected.
- 2×8 connector, easy with the MCU mount.
- Jumper selectable can work in parallel or serial mode.
- USB status indicator.
- On board 3.3 V LDO 1117, provides 800 mA current.
- Colour: Blue
SPECIFICATIONS:
- IC Chip: CH375B
- LDO: 3.3V
- Input Voltage Range(VDC): 5
- Crystal: 12 MHz
- PCB Size ( L x W ) mm: 48 x 28
- Weight (gm): 6
